(Scenarios may contain multiple errors which may or may not impact the solution ) Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes

The VSX cluster is not forming. Which modification should you make to resolve the error condition?

• A. Edit the vsx-sync command, adding "keep-alive"
• B. Modify the system interface-group 4 speed tOg command change "25g" to "10g"
• C. Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing "vrf KA" to "vrf mgmt"
• D. Modify the vsx definition, changing "inter-switch-link lag 2" to" inter-switch-link lag 256"

(Scenarios may contain multiple errors which may or may not impact the solution) Refer to the Exhibit.

An engineer has attempted to configure two pairs of switches m the referenced configuration it Is required to implement Multi-Chassis Link Aggregation for each pair of switches The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows

The configuration includes:

There is an error message stating "mismatched group speed" What should you add to the configuration to correct the error?

• A. "speed 10-full" under interfaces 1/1/12 and 1/1/13
• B. "system Interface-group 1 speed I0g"
• C. "allow-unsupported-transceiver
• D. "speed 40-full" under interfaces 1/1/49 and 1/1/50

When an ArubaOS-CX switch uses the temporary copy of the coring state database, how does NetEdit validate if the configuration is correct?

• A. Planned validation
• B. Deploy validation
• C. Syntax validation
• D. Semantic validation

Refer to the exhibit.

A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?

• A. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.
• B. Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.
• C. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports
• D. Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.

A customer would like to utilize some ArubaOS-CX 6300M switches to perform OSPF routing.

All ports are routed, and ECMP is enabled, with other default parameters for OSPF. What will be the result of traffic sent from CLIENT-A to CUENT-B?

• A. Traffic will be SW3 -> SW-1 -> sw-4 -> SW-2
• B. Traffic will be SW3 -> SW-4 -> SW-2.
• C. Traffic win be SW3 -> SW-1 -> sw-2.
• D. Traffic will be SW3 -> SW-1 -> Sw-2 & SW3 -> SW-4 -> SW-2