[2024] Pass CWNP CWDP-304 Premium Files Test Engine pdf - Free Dumps Collection [Q44-Q65]

Share

[2024] Pass CWNP CWDP-304 Premium Files Test Engine pdf - Free Dumps Collection

New 2024 Realistic CWDP-304 Dumps Test Engine Exam Questions in here

NEW QUESTION # 44
An engineering firm just upgraded their WLAN form nine 802.11n APS to nine 802.11ac APs. After this upgrade, they did not see any improvement in throughput.
What is the most likely cause of this result?

  • A. APs are mounted on the wall
  • B. The APs are still using the 5 GHz lower band
  • C. APs are transmitting at a low transmit power
  • D. The clients were not upgraded

Answer: D


NEW QUESTION # 45
As you plan a WLAN upgrade, you have assessed the network requirements and data signatures of your applications. One of the popular applications used on your network requires high bandwidth and low to medium Wi-Fi loss, but can tolerate moderate latency and jitter.
What application matches this description?

  • A. Video-on-demand
  • B. Email
  • C. Voice
  • D. Skype chat

Answer: B


NEW QUESTION # 46
What functions may be performed by a WIPS?(Choose all that apply.)

  • A. Client access to the distribution system
  • B. Automated threat mitigation
  • C. Distributed protocol analysis
  • D. Performance monitoring and response
  • E. Data forensics and analysis

Answer: B,C,D,E


NEW QUESTION # 47
What is the most suitable antenna option to be used when designing a WLAN infrastructure with APs mounted on a ceiling with a height of more than 20 feet and having all of the client stations used from the floor?
Response:

  • A. Patch
  • B. Grid
  • C. Dish
  • D. Low-gain dipole

Answer: A


NEW QUESTION # 48
You are site surveying a network for VoWiFi. You have positioned an AP for a manual survey and are moving away from the AP with a phone in Survey Mode in your hand and you are reading the RSSI value of the signal received from the AP. You have previously determined that the noise floor was approximately -94 dBm on this floor of the building. The phones documentation does not specify a recommended RSSI or SNR value for best performance.
Based on the information provided and the type of device (VoWiFi phone) you are deploying, what minimum RSSI should you plan for in all areas you are monitoring and where VoWiFi service is desired?

  • A. - 75 dBm
  • B. - 72 dBm
  • C. - 62 dBm
  • D. - 67 dBm

Answer: D


NEW QUESTION # 49
What are some advantages of designing guest access with all guest users tunneled directly into the DMZ?
Response:

  • A. Allows a single SSID with different authentication/encryption models to be used for all WLAN services for corporate users and guests
  • B. The border firewall configuration will not require any additional rules to pass guest traffic to the DMZ controller
  • C. Minimizes configuration requirements for segmentation and filtering of guest traffic across internal LAN
  • D. Enhances performance of web proxy servers in the DMZ for guest Internet traffic

Answer: B,C

Explanation:
Designing guest access with all guest users tunneled directly into the DMZ has two main advantages: it simplifies the network configuration and it enhances the security of the internal network. A DMZ is a demilitarized zone, which is a separate network segment that isolates the public-facing services from the private network. A DMZ providesa buffer zone between the Internet and the internal network, where potential attacks can be detected and prevented.
By tunneling all guest users directly into the DMZ, the network configuration is simplified because there is no need to segment and filter the guest traffic across the internal LAN. The guest traffic is encapsulated and routed to the DMZ controller, which acts as the anchor point for the guest WLAN. The guest traffic is then decrypted and forwarded to the Internet or the DMZ services. This way, the guest traffic does not mix with the internal traffic, and there is no need to apply VLANs, ACLs, or firewall rules to separate them.
Another advantage of tunneling all guest users directly into the DMZ is that it enhances the security of the internal network. By keeping the guest traffic in the DMZ, the internal network is protected from any potential threats or attacks that may originate from the guest users. The guest users have no visibility or access to the internal network resources, and they are subject to the security policies and controls of the DMZ. The border firewall configuration will not require any additional rules to pass guest traffic to the DMZ controller, because the guest traffic is already encapsulated and tunneled. This reduces the complexity and the risk of misconfiguration of the firewall rules. References: CWNP, CWDP Certified Wireless Design Professional Official Study Guide, Cisco Unified Wireless Guest Access Services, What Is a DMZ Network and Why Would You Use It?, Wireless Guest Access FAQ


NEW QUESTION # 50
When installing APs on high ceilings, what should be the most common PPE to be used?

  • A. Clean suits, masks and glasses
  • B. Glasses, gloves and jacket
  • C. Hardhat, high visibility vest and body belt
  • D. Clean suits, gloves and jacket

Answer: C


NEW QUESTION # 51
In a large enterprise (5000+ wireless users), by what would NOT be a recommended method by which IP addresses and VLANs are assigned to different clients associated to the same AP?

  • A. Radio signal metrics (RSSI, SNR, etc.) of WLAN clients are triangulated for location-based VLAN assignment during association
  • B. Upstream AAA servers dynamically assign VLANs to each user or group profile
  • C. Each SSID is mapped to a static VLAN assignment
  • D. Multiple VLAN pools are designated for an SSID and user IP addresses are selected in a round-robin fashion from the associated pools

Answer: A


NEW QUESTION # 52
A company wants to connect its headquarters to its remote office that is 13 kilometers away using a wireless bridge. What requirement must not be forgotten by their Wireless Engineer when considering the Fresnel Zone?

  • A. Antenna gain
  • B. Earth bulge
  • C. FSPL
  • D. Receive sensitivity

Answer: B


NEW QUESTION # 53
Given: For this fill-in the blank question, each answer option contains an answer for the first and second blanks, separated by a dash "-". Choose the answer option that correctly fills in both blanks in the following sentence.
A WLAN may use 802.11 admission control to ________, and admission control requirements are configured separately for each ________.

  • A. Regulate the available bandwidth resources - Access Category
  • B. Mark ingress and egress frames with priority values - TCP/IP port
  • C. Block stations with inadequate security parameters - SSID
  • D. Identify voice-enabled wireless devices - AP radio (that is, 2.4 GHz or 5 GHz)

Answer: A


NEW QUESTION # 54
During a customer walkthrough you notice an area of the CAD drawing where it is not accurate. What next step should you take?
Response:

  • A. Redraw the portions of the map that have changed.
  • B. Do not survey that area.
  • C. Request a new version.
  • D. Request the survey team to do their best to walk where necessary and use the references on the map.

Answer: C


NEW QUESTION # 55
During a post-validation assessment, you have configured a client for 802.1X/EAP but it is not passing authentication. Which areas should you check in the WLAN configuration?
Response:

  • A. Whether the client has a fully valid certificate
  • B. Whether the RADIUS shared secret is properly configured on the supplicant and authentication server
  • C. Whether the authenticator is configured to support the EAP type(s) your client is configured for
  • D. Whether the RADIUS server is online and configured for the matching port on the APs and WLAN controllers

Answer: D


NEW QUESTION # 56
What important item is often left out of operational and maintenance plans?
Response:

  • A. Network overview
  • B. Configuration backups
  • C. Syslog analysis
  • D. Engineering feedback

Answer: D


NEW QUESTION # 57
An enterprise customer is subject to the highest standards for network uptime. When designing their wireless network, you should consider which of the following?(Choose all that apply) Response:

  • A. The failover of the wired network only
  • B. The failover of the wireless network only
  • C. The failover of the wireless and wired network
  • D. The physical aspects such as power and cabling

Answer: C,D


NEW QUESTION # 58
What type of standards-based encryption is used by office extension APs for the traffic tunnel?(Choose all that apply.) Response:

  • A. LWAPP
  • B. CAPWAP
  • C. AES
  • D. TKIP
  • E. DTLS

Answer: E


NEW QUESTION # 59
What type of standards-based encryption is used by office extension APs for the traffic tunnel?(Choose all that apply.)

  • A. AES
  • B. LWAPP
  • C. CAPWAP
  • D. DTLS
  • E. TKIP

Answer: A


NEW QUESTION # 60
What limitation exists when WMM is not enabled on an 802.11n WLAN?

  • A. EDCA values will change
  • B. 802.11 QoS will not be available
  • C. The maximum channel-width will be 20MHz
  • D. Only two ACs will be available

Answer: B


NEW QUESTION # 61
For an antenna 35 dBi of gain is needed. What antenna type should be used to achieve this gain?
Response:

  • A. 4 dipole
  • B. Yagi
  • C. Dish
  • D. Horn

Answer: C


NEW QUESTION # 62
When selecting a centralized WLAN architecture, what new problem may arise when you change the data forwarding model from centralized to distributed?
Response:

  • A. All RRM controls will also need to be distributed to a master AP that acts as a channel and transmit power arbiter for other APs in the ESS.
  • B. The router between the APs and the controller must be made aware of the APs as forwarding client STAs.
  • C. APs that were designed for a centralized forwarding model may not support all features in distributed forwarding mode.
  • D. Centralized control functions, such as key management and distribution, RRM, and load balancing will no longer be supported.

Answer: C


NEW QUESTION # 63
Given: In a site survey deliverable report, you are expected to explain the spectrum measurements taken at the customers site. What portion of a spectrum analyzer view can be used to determine if a given channel is too active for use as the active channel for a new AP?

  • A. Device list
  • B. Frame decode
  • C. Duty cycle
  • D. Real time FFT

Answer: C


NEW QUESTION # 64
When designing a WLAN to support voice in a large office, which design element is of the highest concern for performance?

  • A. AP vendor
  • B. Frequency Selection
  • C. Band steering
  • D. Roaming

Answer: D


NEW QUESTION # 65
......

Updated Official licence for CWDP-304 Certified by CWDP-304 Dumps PDF: https://www.vceengine.com/CWDP-304-vce-test-engine.html

Newly Released CWDP-304 Dumps for CWDP Wi-Fi Design Certified: https://drive.google.com/open?id=1pnHfhBK3436d6tMcYstJnAowsyWnHYyd